Cat6A RJ45 180-Degree Shielded Die Cast Keystone, Slim Type

110 IDC fully shielded 180-degree punch down jack

This fully shielded 180 degree jack is perfect for shielded networks. The die cast body is backwards compatible with components and systems of lower performing categories. Use in standard keystone wallplates, patch panels, or surface mount boxes.

Installation

Step 1: Strip approximately 40mm of the cable jacket and then fold back the foil and the braid shield.
Step 2: Follow the labelled colors on the modular covera and set each wire into the proper position to ensure the ground wiring connects properly.
Step 3: Place the assembled modular cover into the module and cut the wires evenly to fit.
Step 4: Complete assembly by closing the module and then trim any excess wire.

Step 1: Strip approximately 40mm of the cable jacket and then fold back the foil and the braid shield.

Step 2: Follow the labelled colors on the modular covera and set each wire into the proper position to ensure the ground wiring connects properly.

Step 3: Place the assembled modular cover into the module and cut the wires evenly to fit.

Step 4: Complete assembly by closing the module and then trim any excess wire.